Operation:
Clamp work piece:
- Rotate the screw knob (18) and loosen the clamp (23). Put work piece in the clamp and then tighten the
screw to hold the work piece securely.
Adjust the position and angle of work piece:
- Loosen the screws (25) to adjust the position and angle of the clamp (24). Tighten the screws after the
position is adjusted. Please ensure that the work piece should be in the centre of cutting disc.
Cutting
:
- Switch on the angle grinder and press down handle (10) to cut the work piece with the angle grinder.
MAINTENANCE
- The stand requires almost no maintenance.
- Regularly clean it with a soft, damp cloth of oil, dust, sawdust, etc.
- Damaged stand for angle grinder must only be repaired by an authorized service center.
ENVIROMENTAL PROTECTION
The symbol of the cross-out wheelie bin on the products or in the accompanying
documents means that the used products must not be added to normal municipal waste.
For proper disposal, recovery and recycling, deliver these products to designated
collection points where they will be received free of charge. Alternatively, in some
countries you can return your products to a local retailer when buying an equivalent new
product. Proper disposal of this product will help to conserve valuable natural resources
and help prevent potential negative impacts on the environment and human health, which
could be the consequences of improper disposal of waste. Please contact your local authority or nearest
collection point for further details. Incorrect disposal of this type of waste may be subject to fines in
accordance with national regulations
