Strebel BCa7s, Инструкция по установке и эксплуатации

Страница: 13 / 22

Page 13
23/03/01
ASSEMBLY INSTRUCTIONS FOR: Ca 7s / BCa 7s
The jacket assembly is completed by following the steps
below:
•
The sensors (4) must be pushed into the sensor pockets at
the rear of the boiler (max. of 3 per pocket)
•
The calorifier control thermostat sensor (5) must be pushed
into the lower sensor pocket with the retaining spring.
•
The calorifier thermometer (6) must be pushed into the
upper sensor pocket.
•
All sensor leads (capillary leads) must not be kinked.
Note:
Mains connection should be
made via the rear of the boiler
through to the control panel. It
must not be connected directly
to the front of the boiler via
the calorifier jacket door.