Streamax AD Plus2.0, Руководство пользователя

Страница: 29 / 32

AD Plus2.0 User Manual
Page 28 of 66


N9M : indicates the protocol type for the device to report information to
the video surveillance platform CEIBA2.


808 : indicates the protocol type for the device to report information to the
808 platform (not used for overseas trucks).
4. Enable Network : can be set to Local, WIFI, or Communication Module.
5. Register Server IP : specifies the IP address of the register server of the
platform to which the device reports information.
6. Register Server port : specifies the corresponding device port through which
the device reports information to the platform.
7. TLS encrypted port number: during the normal startup and operation of the
device, the interactive data between the device and the platform is transmitted
through TLS encryption, which can ensure the security of the interactive data
between the device and the platform. Data interaction in dormant state is not
encrypted. For the usage, you need to enable TLS and configure the encrypted
port number. Currently, only TLS encryption for the CEIBA3 platform is
supported.
8. Media Server IP: specifies the IP address of the media server of the platform to
which the device reports information.
9. Media Server port: specifies the corresponding device port through which the
device reports information to the platform.
The registrar and media server have the same default IP address and port
number.
10. It supports 4G SIM cards, which can provide mobile hotspots for mobile
terminals such as mobile phones and pads for Wi-Fi network transmission.
In order to prevent end users from using traffic beyond the control or forgetting
the password, the dealer needs to control the account and password. However,
it is impossible to set the device on site due to the site environment. In this case,
you can send SMS messages to enable/disable hotspots or change the account
password in the AP mode.
The Wi-Fi module allows modifying parameter formats and contents by
sending SMS messages, as shown in the following:
Command keyword: WIFI
Enable. 1 : Enable; 0 : Disable
99admin,120223,WIFI0 -- None
99admin,120223,WIFI1 -- Client
99admin,120223,WIFI2 -- AP
The command parameters have different formats and contents due to different
parameters in different modes:
1) AP mode:
Command parameters:
Mode
,
Encryption Type
,
ESSID
,
Password
, and
Hotspot Enable !
Example:
99admin,120223,WIFI2,WPA,streamax,streamax,1!