Stream ContentCentre, Инструкция по установке и эксплуатации

Страница: 20 / 37

First time setup
Starting Up/Shutting Down
Due to the storage capabilities of the ContentCentre it is very
important that it is started and shutdown correctly. Do not under
any circumstances remove the power connection or hold the power
button to shut down the unit unless advised to do-so by a support
technician. Instead, a single press of the power button starts the
ContentCentre shutting down in a safe manner.
In the event of a power cut the ContentCentre will automatically
0=0;HB48CKBL;4BHBC4<0=3A4?08A8C85=478B<0HC0:40=
long time for units with large storage capacity (sometimes > 24
7>DAB
3*.(4)&42&"-&%*"834&-'/24)&:2344*-&
1. It is not necessary to have a permanent video connection to the
ContentCentre. However, depending on the router being used it
<867C14?A454A01;45>ALABC C8<4B4CD?C70C038B?;0H>A<>=8C>A
is connected to help identify the IP Address allocated to it by the
router.
2. Connect the supplied PSUs to the ContentCentre and
ContentPlayer using the connection diagram on pages 11-14 of
this manual.
3. Check that the network cables connected to the ContentCentre
and ContentPlayer are correctly connected to the network switch
and have an internet connection.
4. Make sure that an HDMI, VGA or DVI cable is connected to the
ContentPlayer and that a Display device is connected to the
other end. This is very important - without a valid video
connection the ContentPlayer will not start up.
5. Press the power button once on the ContentCentre and
ContentPlayer to switch them on.
16 - Stream Media System Installation and User Guide