Information
s Générales
This equipment operates at voltage levels that are potentially lethal. Do not
touch any of the internal parts of the equipment unless you are fully aware
of the hazards involved and the precautions to be taken.
It is imperative to provide an adequate earth conductor for the rack and
load connections. Do not rely on earthing via conduit or trunking.
The equipment described in this manual is designed and manufactured to comply
with international safety standards IEC 950 and is intended for use as part of a
lighting control system. It must not be used for other purposes where there is any
risk of safety to persons. It is important that installation be carried out in
accordance with the instructions given in this manual and in compliance with
applicable electrical regulations. The work should be carried out by a suitably
qualified electrician.
The system is designed to be permanently installed with supply and load wiring
permanently connected.
In the interests of continued safe and reliable operation, observe the following
guidelines:
x
Keep the equipment at a room temperature of 0-35
q
C and a relative humidity
of 10-95% (non-condensing) during operation. For operation between 35
q
C and
40
q
C de-rate the maximum load by 4% per
q
C.
Do not, under any circumstances, operate the equipment above 40
q
C or in an
environment that may become wet.
x
Avoid sudden extremes of temperature, rain, direct sunlight, or other heat
sources.
x
Make sure that wires and cables are routed sensibly and wired in
accordance with local regulations.
x
DO NOT drop the equipment or subject it to excessive bumping or jarring.
x
DO protect the unit from excessive dust or other contamination.