Stramatel Multisport 452 Series, Технические данные - Инструкции по установке

Страница: 8 / 10

Multisport 452
ZI de Bel Air 44850 LE CELLIER FRANCE stramatel@stramatel.com Tél. +33 (0)2 40 25 46 90
IASC24_A - Installation SC24.docx Page 3
R
S T
460
260
F
F
F
F
R
Installation on the floor (radio-controlled model only)
Caution: the display units must not be connected to mains before installation has been fully completed.
Mains cables: only use the power cables provided. These cables are equipped with pre-wired plugs; the wiring should not be
modified.
Open the compartment door (R) at the back of the display units.
Connect the mains cables in the display units - Connectors 100-240VAC (S).
Put the compartment door (R) back into place, making sure the cables are in the passage provided for this purpose.
Close and screw the compartment door (R).
Clamp the stands (H) under the display units.
Plug each display unit into an appropriate mains (+ earth) outlet (the socket should be as close as possible to the display
unit and must be easily accessible).
Installation on support frames (mounted on backboard support frames)
Caution: the display units must not be connected to mains before installation has been fully completed.
Mains cables: only use the power cables provided. These cables are equipped with pre-wired plugs; the wiring should not be
modified.
Mounting points (F): drill 4 holes (diameter 6,2 mm) into each support frame following the measures of the diagram
(support frames not supplied).
Using a large flat screwdriver, remove the 4 round caps (F) at the front of the display units.
Using 4 screws M6x50 (not supplied), mount each display unit into place on its support frame.
Fit the caps (F) back into place.
Open the compartment door (R) at the back of the display units.
Cable transmission model or radio-controlled model supplied with the cable kit option: install the control cables and the
wall junction box (see page 5).
Connect the mains cables in the display units - Connectors 100-240VAC (S).
Put the compartment door (R) back into place, making sure the cables are in the passage provided for this purpose.
Close and screw the compartment door (R).
Fix the cables onto the support frames.
Plug each display unit into an appropriate mains (+ earth) outlet (the socket should be as close as possible to the display
unit and must be easily accessible).
S
T
H
S
T