STOVES S7 E450BCMAUTO, Руководство пользователя

Страница: 18 / 28

Personalising Your Coffee Maker
12.4 Changing coffee temperature
To change the temperature of the coffee, proceed as follows:
• Press the button (the light over the button comes on) then press the but-
ton repeatedly until the appliance displays:
• Press the button until the appliance displays the required coffee temperature
• Press the button to confirm the temperature selected;
• Press the button to exit programming mode or to change other parameters.
12.5 Changing the length of time the appliance remains on
The appliance is factory preset to go off automatically one hour after the last coffee has
been made.
The number of hours the appliance remains on can be increased as follows:
• Press the button (the light over the button comes on) then press the button
repeatedly until the appliance displays:
• Press the button to change the number of hours the appliance remains on
• Press the button to confirm the value;
• Press the button to exit programming mode or to change other parameters.
12.6 Setting water hardness
The descale message is displayed after the appliance has been operated for a factory set
period of time calculated on the basis of the maximum quantity of lime scale which may be
contained in the water used. If necessary, this period of operation can be extended, mak-
ing descaling less frequent, by programming the appliance based on the actual lime content
in the water used. Proceed as follows:
• Remove the "Total Hardness Test" strip (attached to this book) from its packaging then
dip it fully in the water for a few seconds, Remove it and wait around 30 seconds (until
it changes colour and a number of red dots are formed);
• Turn the appliance on by pressing the button (fig. 4).
• Press the button then press the button repeatedly until the appliance displays:
• Press the button repeatedly until the number coincides with the number of red
squares on the test strip (for example, if there are 3 red squares on the test strip, press
the button until WATER HARDNESS 3 is displayed).
• Press the button to confirm the value. The coffee maker is now programmed to
provide the descaling warning when necessary, based on the actual hardness of the
water.
12.7 Resetting factory default settings
Should you wish to fully re-set the appliance, the factory settings can be restored by follow-
ing the instructions below:
• Press the , button then press the button repeatedly until the appliance dis-
plays:
• Press the button and the appliance displays “RESET TO DEFAULT YES”;
• Press the button to reset the factory default values;
• Press the button to exit programming mode or to change other parameters.
18
RESET TO DEFAULT NO
WATER HARDNESS 4
OFF AFTER 1 HOUR
TEMPERATURE MEDIUM