STOVES S7 E450BCMAUTO, Руководство пользователя

Страница: 13 / 28

Using Your Coffee Maker
10 PREPARING CAPPUCINOS (USING STEAM)
• Move the Cappucino maker outwards (fig. 2).
• Place an empty container under the Cappucino maker. Start the steam/hot water delivery
by turning the control knob counterclockwise to the ‘On’ position.
The appliance displays:
• Allow the steam mixed with water to run for a few seconds until there is only steam.
• To stop using steam, the steam/hot water delivery knob should be turned clockwise (fig.
18).
• Empty the container (there will be water inside) then re-fill it with about 100 grams of
milk for each Cappucino to be prepared. When choosing the size of the container, bear
in mind that the milk doubles or triples in volume. We recommend you use semi-skimmed
milk straight from the refrigerator
• Dip the Cappucino maker into the milk (fig. 2), taking care not to immerse the raised line
on the Cappucino maker (indicated by the arrow in fig. 19). Turn the steam/hot water
delivery knob to the ‘On’ position. Steam is discharged from the Cappucino maker, giving
the milk a creamy frothy appearance. To obtain a creamier froth, dip the Cappucino maker
into the milk and rotate the container with slow movements from the bottom upwards.
Note: You should not discharge steam for more than two minutes at a time.
• Once the milk is frothed to your taste, stop the steam delivery by turning the knob clock-
wise (fig. 8).
• Prepare the coffee as described in section 8, using large enough cups, then top with the
frothed milk prepared previously. The Cappucino is ready. Sweeten to taste and then
sprinkle the froth with a little cocoa powder if desired,
IMPORTANT: always clean the Cappucino maker immediately after use. Proceed as fol-
lows:
• Discharge a little steam for a few seconds by turning the control knob. This clears any
milk left in or on the steam spout.
IMPORTANT: to guarantee hygiene, you are recommended to follow this procedure
each time you make Cappucino to avoid stale milk in the milk circuit.
• Wait a couple of minutes for the Cappucino maker to cool down then with one hand hold
the Cappucino spout handle firm and with the other unscrew the Cappucino maker itself
by rotating clockwise and pulling downwards (fig. 20).
• Remove the nozzle from the steam spout by pulling it downwards (fig. 21).
• Carefully wash the Cappucino maker and steam nozzle in warm water.
• Make sure the two holes shown in fig. 22 are not blocked. If necessary, clear with a pin.
• Replace the steam nozzle by inserting it and vigorously turning it upwards into the steam
spout.
• Replace the Cappucino maker by pushing it upwards and turning it anticlockwise.
13
STEAM