Connect to the electricity supply
Warning:
This appliance must be
earthed.
The appliance must be installed by a
competent electrician using a double
pole control unit of 30 ampere minimum
capacity with 3mm minimum contact
separation at all poles.
We recommend that the appliance is
connected by a qualified electrician
who is a member of the N.I.C.E.I.C.
and who will comply with the I.E.E.
and local regulation.
1. Access to the mains terminal is
gained by opening the terminal
block cover at the rear of the
appliance (use a small flat-bladed
screwdriver).
2. Connection should be made with
6.0mm
2
flexible twin and earth
cable.
3. First strip the wires, then push the
cable through the cable clamp in
the terminal block cover.
4. Connect the cable to the terminal
block and tighten the cable clamp
screw (see diagram).
5. Close the terminal box, ensuring
that the cover is engaged on the
locking tabs.
32
INSTALLATION INSTRUCTIONS
1
2
3
4
5
Cable
clamp
Earth
(Green / Yellow
or sleeving)
Live
(Red or Brown)
Neutral
(Black or Blue)
Live , Neutral , Earth .
Links to be fitted as shown. Ensure
terminal screw heads and
are fully tightened.
1
2
4
5
Warning:
Do not use the ceramic hob
if the glass is cracked, as electrical
parts are immediately beneath.
Switch off the electricity at the cooker
control unit, and contact your supplier.
Before using the hob for the
first time
Before using the hob for the first time,
apply a thin coating of cleaner
conditioner (eg; “Hob Brite” by
Homecare* - refer to cleaning section
for further information) and polish the
surface with a clean dry cloth.
The conditioner gives a protective
covering to the ceramic glass which
not only makes the hob easier to
clean, but also ensures you will gain
maximum life out of this product.
Using the hotplate elements
To switch on, turn the control knob for
the selected hob element to the desired
setting.
Note:
The marked settings on the hob
controls do not indicate any set
temperature and cannot be used to
compare the performance of one ring
with another.
The hob rings will cycle on and off
automatically during use as a means
of regulating heat output.
To switch off, return the control knob to
the “off” position.
The hot hob light
The hob light comes on when one of
the rings is switched on, and will stay
on for a while after the last ring is
switched off, to indicate that the hob
glass may still be warm.
Care and cleaning
See ‘Cleaning the Hob’ section.
5
USING THE HOB
Содержание EC600EMDOa
Страница 2: ......
