Storz DUOLITH SD1 R-SW, Руководство по эксплуатации

Страница: 15 / 142

1-3
17 361 02 1119
General safety information
Checks and inspections prior to treatment
Before using the device, the user must make sure it is functioning safely and that it is
in proper condition.
• It is essential to perform the functional checks after switching on the DUOLITH
®
SD1,
before starting treatment. Read about this in
C
hapter
4.6.3 f
unCtiOnal CheCks and
C
hapter
4.7.3 f
unCtiOnal CheCks
.
• Have the maintenance procedures recommended by the manufacturer carried out by
authorised personnel (see also
C
hapter
6.6 M
aintenanCe and safety CheCks
).
Protection against electrical hazard
Sources of voltage can give rise to currents as a result of body resistance which not
only flow through the patient but can also impair or even endanger the physician and
the nursing staff.
• Therefore, always connect the potential equalisation connector of the DUOLITH
®
SD1
in accordance with national guidelines.
• Devices which are not medical products in accordance with EN 60601 must be set
up outside the vicinity of the patient.
• Do not touch electrical connectors while you are touching the patient.
• Disconnect the DUOLITH ® SD1 from the mains before starting any cleaning or
maintenance work!
• Disconnect the connected handpieces from the device before carrying out cleaning
and maintenance work. Do not reconnect them until they have been completely
reassembled!
• The optional KARL STORZ foot switch must not be used in potentially explosive
atmospheres according to classification AP as per IEC 60601.
Protection against high voltage
Very high voltages are generated in the F-SW module when operating the device.
High-voltage components are identified as follows:
DANGER!
Opening the device and touching high-voltage parts can result in
serious or fatal injuries!
• Only operate the device if the housing is intact and closed.
•
Do not start work in the high-voltage area before first switching
off the electrical supply and waiting for 2 minutes.
• Work in the high-voltage area is only allowed to be performed by
personnel suitably authorised by the manufacturer.