Page 44 /59
snengde_installation-product-SN-range v1.2 - Copyright Netasq 2015
PRESENTATION AND INSTALLATION GUIDE – SN RANGE
APPENDIX B: RESETTING THE FIREWALL
APPENDIX B: RESETTING THE FIREWALL
It is possible to restore the default factory settings of a Stormshield Network Firewall. This operation will bring
the product into its initial configuration. This reinitialization does not modify the firmware version and only
affects the active partition.
WARNING
Resetting a Firewall will completely remove the configuration made on the product. This
operation is irreversible, so do not apply this procedure unless absolutely needed. You are
therefore advised to make a prior backup.
This reset operation may take up to 10 minutes, so do wait until the end of the reboot procedure before
reconnecting to the Firewall.
NOTE
The
Online
and
Status
LEDs will blink throughout the entire initialization phase. 2 consecutive
beeps (except on SN150 models) and the lighted up
Online
LED indicate the end of the
product’s startup sequence.
WARNING
This operation will also reinitialize the administrator’s password. The login and password are
“admin” by default.
All models except SN6000
In order to reset your Firewall, take a pointed object. A small pushbutton is accessible through a hole located
in the following places:
-
on SN150 models, on the rear panel of the product, between the Ethernet interfaces and the plug
of the mains adapter
-
on SN200, SN300, SN500, SN700 and SN900 models, on the front panel of the product, between
the USB port and VGA port.
-
on SN910 models, on the front panel of the product, between the extension module slot and the
Ethernet interfaces.
-
on SN2000 and SN3000 models, on the front panel of the product, between the LEDs and SSD
racks.
SN150 model
SN200, SN300, SN500, SN700 and SN900 models
