page 7
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket and
remove screw closest to the open end of the hanging
bracket. Partially loosen the other screw. Lift canopy
to hanging bracket. Place rounded part of slotted
hole in canopy over loosened screw in hanging
bracket and push up. Twist canopy to lock. Re-insert
screw that was removed and then tighten both
screws securely.
Slide canopy cover up to canopy, aligning rounded
part of slotted holes in canopy cover with screwheads
in bottom of canopy. Turn canopy cover to the right
(clockwise) until it stops.
*Remember that antenna for remote control receiver
must rest
outside
of hanging bracket.
8. Blade Assembly.
WARNING
: To reduce the risk of serious bodily
injury,
DO NOT use power tools to assemble the
blades. If overtightened, blades may crack and
break.
Locate 6 blade attachment screws/washers in
hardware pack. Align blade holes with motor screw
holes on the UNDERSIDE of the motor housing.
Place blade plate
UNDERNEATH
the blade, aligning
holes in blade plate with holes in blade
as shown
.
To attach blade, insert 2 screws/washers with
fingers first and then secure with a Phillips
screwdriver. Repeat procedure for each remaining
blade.
NOTE
: Tighten blade screws twice a year.
canopy
hanging
bracket
screw
screw
canopy cover
antenna
receiver
motor
housing
blade
blade screw/washer
blade plate
