page 8
Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws.
Align slotted holes in fitter plate with loosened
screws in motor plate, allowing molex
connectors to come through center hole in
fitter plate. Twist fitter plate to lock. Re-insert
screw that was previously removed and
securely tighten all 3 screws with a Phillips
screwdriver.
Remove 1 screw from underside of fitter plate
and partially loosen the other 2 screws.
Connect
WHITE
wire from motor housing to
WHITE
wire from the LED light kit and
BLUE
(or
BLACK
)
wire from motor housing to
BLUE
wire from LED light kit. Make sure molex
connections snap together completely.
Carefully arrange wiring within the back of
LED light kit. Align slotted holes in LED light
kit with loosened screws in fitter plate.
Re-insert screw previously removed and
securely tighten all 3 screws with a Phillips
screwdriver.
Locate slots on shade and align with nodules
on inside of fitter plate.
Gently push up on
shade and turn
to the RIGHT (clockwise)
until it
slides completely into place.
9. Light Kit Assembly .
motor plate
motor housing
fitter plate
screw
molex connections
fitter plate
molex connections
LED light kit
motor housing
shade
nodules
slots
motor housing
