StorCase Technology Data Silo DS100, Руководство пользователя

Страница: 17 / 33

8 Installation
StorCase Technology, Inc. DS100 (U320) User's Guide - Rev. A02
IF INSTALLING A 8-BIT SCSI DEVICE:
The unit ID cable contains black , brown , red/black , and orange wires. Attach three (3)
connectors from the SCSI ID select cable to the appropriate 2mm drive pins (Figure 7). The
fourth (orange) wire is not used for the 8-bit installation.
The single
black wire plugs into the drive pin used to select ID1, the brown wire plugs into
the drive pin for ID2, the red/black wire plugs into the drive pin for ID4. The orange wire
is not used for this interface.
In most cases, the drive manufacturer labels each pair of SCSI ID select pins in significant bit
order (0, 1, and 2). One row of drive pins is the signal row, and one row is designated for
ground (refer to the drive manufacturer's documentation for specific pin configurations).
The DS100 ID select cable provides 2mm, 2-conductor drive connectors. A single wire
attaches to one side of each connector (with the exception of the red/black connector). The
cable side of each connector must align with the signal pin on the drive. On the red/black
connector, the red wire aligns with the signal pin on the drive and the black wire aligns with
the ground pin.
NOTE: Some versions of the Data Silo have a reversible ID select cable. This cable may
be attached to either 2mm or 1.25mm drive pins.
Figure 7: 8-Bit SCSI ID Cable Connection
ID Select Cable (2mm) from
Data Silo ID Select Connector
0
1
2
Typical Drive 8-Bit Single-Ended ID Select Pins
(Pins vary on each drive model. See Drive
Manufacturer's Manual.)
0538A
Signal Row
Black (ID0)
Brown (ID1)
Red (ID2)
Black (GND)
GND Row
ID Select
Cable
2mm Drive
Connectors
Black (ID0)
Brown (ID1)
Red (ID2)/Black (GND)
Orange (Not Used)
TO
SCSI ID Select
Connector (1.25mm)
SCSI ID Select
Connector (2mm)
ID0 ID1 ID2 Not Used
Ground
Row
Pin 1
All manuals and user guides at all-guides.com