Stonex S990A GNSS Receiver – User Manual v1.0
18
2.5.2
Base
Base mode in plus respect the rover has the specific parameters of the base.
For example you can set the base data type, start base and base position and
so on.
Important parameters are the position of the base. User cas set as Base
position Single if the position of the base is unknown or insert directly the
coordinates of the base point selecting Repeat Position.
If you select UHF mode, most of the settings are same as rover. But you can
set the radio power. To obtain best performance it is necessary set HIGH. The
protocols are divided in 2 groups in base of the frequency range: 410/470 Mhz
or 900 Mhz.
If you select Network, as the roveri s possible set the data type, site ID, base
position and record raw data, the most important is you can input APN
account, APN user and password, connect mode, caster address and port. In
plus there are always the parameter of the coordinate of the base.
