STONEFLY DR365-HA, Быстрый старт

Страница: 16 / 25

This section will provide step-by-step instructions for initial system configuration and hard-
ware setup of the StoneFly DR365-HA™.
1. Connect both power supply modules to a power outlet using the included power
cords.
2.
Connect an Ethernet cable to the Ethernet port as shown in the picture below:
3. Turn on the power switch in front of the box.
4. Configure a computer to be able to access subnet DHCP since the default IP
address for the StoneFly DR365-HA™ is set to DHCP.
5. A monitor is not needed to access the StoneFly DR365-HA™, but if you have a
monitor hooked up to the box, you will see when the box is ready for access.
6. Open a web browser and in the address bar, type in http://DHCP_IP and hit return .
You will see a screen like the one shown below:
DR365-HA
™
Power Up and Initial Access
DR365-HA
Quick Start Guide
13
Figure 9: System Connections.