11
866-795-1586 • WWW.STONEAGETOOLS.COM
ASSEMBLY
6. Thread the Head (SC125 043-X) onto Outlet End Shaft (SC125 001.2). Use Threadmate
and fluorocarbon tape on the pipe threads.
NOTE: there is a 1/4" hex on the inside diameter of the Shaft for holding the
Shaft when tightening. Tighten to 30 ft-lbs. Apply anti-seize to straight threads of the
Shaft.
7. Install O-Ring (SC125 016) into internal groove in outgoing bore of the Inlet End Shaft
(SC125 001.1). Apply grease to O-Ring.
8. Slide Head/Shaft assembly into the rounded end of the Body. Slide the Inlet End Shaft
into the threaded end of the body and tighten shafts together to 30 ft-lbs.
9. Slide Bearing (SC125 009) into inlet end of Body.
10. Fill the tool with silicone lubricant to 1/4" above top of Bearing.
11. Install the H.P. Seal and Seat as shown in the Maintenance Section and thread the
Body onto the Inlet Nut. Tighten to 50 ft-lbs.
12. Install Port Plug.
SC125 009
Bearing
SC125 003
Body
SC125 016
O-Ring, Viton
SC125 001.1
Shaft, Inlet End
SC125 043-.5 or 1.0
Head
SC125 001.2
Shaft, Outlet End
SC125 002-AMMT
Inlet Nut
CHAMFERED
FACE UP
SC168 011- C
Seat, Carbide
SC125 026
Port Plug
Assembly
SC168 012-O
H.P. Seal
Assembly