11
STEP 3: ASSEMBLING THE LEGS AND BASE
TO THE STAND
See Figures 8 - 9.
Remove the following from the blister pack:
HH
-
4 Bolts (M6 x 55)
II
- 9 Flat washers (6 mm)
JJ
- 9 Lock washers (6 mm)
KK
- 9 Hex nuts (M6)
LL
- 3 Bolts (M6 x 16)
NN
- 2 Bolts (M6 x 62)
There are two U-shaped leg sections.The legs that angle
outward are for the front of the grill. The straight legs are
for the back of the grill.
Make sure the rear leg section is placed with the dimple
facing up.
Set the legs onto the base.
Insert four (4) bolts (
HH
) through the base, leg sections,
and brace as shown.
Slide a washer (
II
), lock washer (
JJ
), and nut (
KK
) over
each bolt and finger-tighten.
To attach the assembled base, legs, and brace to the
supports:
Align the side panel tabs with the slots in the base.
ASSEMBLY
Insert two (2) bolts (
LL
) through the two rounded tabs and
one (1) bolt (
LL
) through the front support and base.
Slide a washer (
II
), lock washer (
JJ
), and nut (
KK
) over
each bolt and finger-tighten.
Insert two (2) bolts (
NN
) through the rear support tabs,
base, rear legs and brace.
Slide a washer (
II
), lock washer (
JJ
), and nut (
KK
) over
each bolt.
Using an adjustable wrench, securely tighten all bolts.
BOLT
(3 - LL)
Fig. 8
BASE
BOLT (4 - HH)
LEG SECTION
(FRONT)
LEG SECTION
(REAR)
DIMPLE
Fig. 9
BRACE
REAR SUPPORT
TAB (FOR BOLTS - NN)
ROUNDED TAB
(FOR BOLTS - LL)
SIDE PANEL TAB
(INSERT INTO BASE)
REAR
SUPPORT
TAB
SLOT FOR
SIDE PANEL TAB
BOLT
(2 - NN)
FRONT
SUPPORT
LEGS
LOCK
WASHER
LOCK WASHER
WASHER
WASHER
NUT
NUT
BASE
