Stoelting CBE117, Руководство пользователя

Страница: 12 / 23

Owner’s Manual #513850 Rev.2 6 CBE Model Machines
B. Control Board
Auger Movement
The Auger Movement button controls the operation
of the augers. The augers must be rotating to start
the refrigeration cycle.
Menu
The Menu button is used to modify machine
settings. Press and hold the Menu button for two
seconds to access the settings. Press the Menu
button to scroll through each option.
Cold Selection
The Cold Selection button will change the
refrigeration cycle depending on the product type
selected. Press the <<>> button to toggle between
standby and the two product types. The display
will show an ice crystal (asterisk) for slush and
water drops (three dots) for cold drink.
Arrow Buttons
The Arrow Buttons are used to change the
consistency or temperature of the product. In slush
mode, the consistency can be changed from 1
(lowest consistency) to 9 (highest consistency).
In cold drink mode, the temperature can be
changed from 2 (lowest temperature) to 5 (highest
temperature).
D. Spigot Lock
The Spigot Lock is a lever located behind the
spigot handle that will lock the spigot handle in
the open or closed position. When the spigot is
in the desired position, push the lever clockwise
to lock it in place. Unlock the spigot by moving
the lever counterclockwise.
E. Minimum Level Sensor
The minimum level sensor is located at the back
of the tank. When the product level in the tank
drops below the probe for 20 minutes the display
will fl ash for 20 seconds every 20 minutes until
the tank is refi lled. If the LowLevel setting is on
(Section 4.2) the display will give a low mix warning
and the slush consistency will change to 2 until
the tank is refi lled.
NOTE
Failure to refi ll the tank immediately may result in
operational problems.
3.3 ASSEMBLY OF MACHINE
All parts should be cleaned, sanitized and allowed to air
dry before assembling.
To Assemble the machine parts, refer to the following steps:
A. Press the gear into bottom of the vertical auger
and install the auger. Secure it to the machine
with the fastening nut.
Cold
Selection
Auger
Movement
Menu
Arrow
Buttons
Figure 3-2 Control Board
CAUTION
Pinch Point
When the spigot handle is locked in the open po-
sition it can pinch and cause injury. Do not place
your hand between the spigot handle and spigot
assembly when it is locked in the open position.
Figure 3-3 Installing Augers
Vertical
Auger
Horizontal
Auger
Gear
Gear
Fastening
Nut