IMPORTANT
:
To avoid assembly problems follow these instructions exactly. Work Safely -
This assembly is
done with the Stockmaster standing upright.
Step 1
-
Lift the Mast into position against the rear of the Platform safety rail and fix thru holes A and B using M6 x
40mm bolts and nyloc nuts. (See illustration No. 1)
Step 2
-
Fix the mast to the Platform at C and D using M8 x 20mm bolts and nyloc nuts. (See illustration No. 2)
Step 3
-
Ensure the mast is vertical and on centre of the rear frame. If necessary, adjust the Mast by loosening the
nuts in steps 1 and 2. Retighten the bolts after adjusting. Fit the Mast Clamp to the bottom of the mast lining up the bolt
with the hole at the Mast centre. (See illustration No. 3)
Step 4
-
Place the Winch Cover over the Winch. Fix the top of the cover to the C slots of the Mast using the Self
Tapping Screws at E and F. (See illustration No. 4)
Step 5
-
Fix the bottom flange of the Winch Cover at G to the Mast with an M6 x 16mm bolt and nyloc nut. Fix the
Winch Handle, Washer and nyloc nut to the Winch shaft and tighten. (See illustration No. 5)
Step 6
-
Rotate the Winch Handle to raise the Mast carraige approximately 300mm up the Mast. (See illustration
No. 6)
Step 7
-
Re-tension the Chain Roller at the bottom of the Mast by loosening the nyloc nut on the inside of the mast
and sliding the Chain Roller down. Hold the Chain Roller in this position and re-tighten the nut. (See illustration No. 7)
Mast Assembly
Illustration 1
Illustration 2
Illustration 3
D
D
C
C
A
B
M6 x 40
M8 x 20
Mast Clamp
Illustration 4
F
E
31
32
