8
After Sales Support
Telephone:
1300 886 649
Email:
Unpacking
•
Unpack the appliance but keep all packaging materials until you have made
sure your new clothes dryer is undamaged and in good working order. Plastic
wrapping can be a suffocation hazard for babies and young children, so ensure all
packaging materials are out of their reach.
•
Make sure to remove the transport packaging at the rear of the clothes dryer.
•
Inspect the cord and plug for damage or wear before each use. Do not use the
appliance if the appliance or its cord have been damaged or are not working
properly. In case of damage, contact our after sales support line.
•
Read all instructions in this manual and make sure you understand all warnings.
•
Wipe the inside of the drum thoroughly with a damp cloth to remove any dust.
Important notes
•
This clothes dryer can be installed on the floor level, upside down, or wall-mounted.
Detailed instructions for each option are provided on the following pages.
•
This dryer is not suitable for direct placement on top of a washing machine.
•
The appliance must not be installed behind a lockable door, sliding door or a door
with a hinge on the opposite side of the clothes dryer.
•
Do not install the appliance in a tight fitting cabinet.
•
Make sure that all electrical connections are made by qualified personnel and all
instructions in this manual as well as local safety regulations are observed.
•
Place the dryer in a dry, well ventilated area, away from heat and direct sunlight.
•
Exhaust air must not be discharged into a flue which is used for exhausting fumes
from appliances burning gas or other fuels.
Floor level installation
•
If the dryer is installed on the floor, make sure to place it on a firm, flat, dry and
stable floor, close to an appropriate wall outlet.
•
Do not place it on soft material such as foam, plastic or carpet, as this will block
the air intake.
•
The dryer comes with legs (that may need to be
assembled) to ensure stability. To avoid damaging
the floor, lay the dryer on a large piece of cardboard
(from the dryer carton) and attach the feet, as
illustrated on the right.
•
See points 3 and 4 on page 11 for installation of the exhaust connector.
•
Stand the dryer on its feet and slide it into position, leaving a space of at least
10cm between the dryer and any wall. Use the adjustable legs to assist in
levelling the dryer, if necessary. When the dryer is level, tighten the legs.
Getting Started: Installation
CAUTION:
This appliance is heavy. Use two or more people to move and install it.
