stimag STL-H/SW, Инструкция по эксплуатации

Страница: 15 / 24

Page 4 of 13
Daily check of the pallet truck can limit wear as much as possible. Special attention
should be paid to the wheels, the axles, as thread, rags, etc. It may block the wheels.
The forks should be unloaded and lowered in the lowest position when the job is over.
5.4 LUBRICATION
All bearings and shafts are provided with long-life grease at the factory. You only need
provide with long-life grease at monthly intervals or after each time the truck is cleaned
thoroughly to the lubrication points.
Chapter 6 Guide To Safety Operation
6.1 Operator should read all warning signs and instructions here and on the pallet truck
before using this truck.
6.2 Do not use on a slopping ground.
6.3 Do not operate a pallet truck unless you are familiar with it and have been trained or
authorized to do so.
6.4 Do not operate a pallet truck unless you have checked its condition. Give special
attention to the wheels or rollers, the draw-bar unit, the fork unit, the lever plate, etc. .
6.5 To pull the truck, always move the control handle into the drive position. This makes
the draw-bar easier to move and depressurizes the pump section of the hydraulics. This
preserves the hydraulic seals and the valve components. A long service life can be
expected.
6.6 Do not take up any people on the pallet truck.
6.7 The operator had better take on gloves for labor protecting.
6.8 When the goods have been transported, all people should be away from the forks for
600mm.
6.9 Do not load goods like fig. 5/B .
6.10 Do not load over maximum capacity.
6.11 At others special condition or place, the operator should be carefully to operate the
pallet truck.