stimag STL-H/SW, Инструкция по эксплуатации

Страница: 14 / 24

Page 3 of 13
3.3 Press the draw-bar (A110, A110B) down, take away the pin(#2) (See Fig. 1).
3.4 Let the control handle (A117) on ‘ RAISE ’ position, then raise the lever plate (A315)
with the pin (#2) and insert the adjusting bolt(A103) into the front slot of lever plate
(A315), note to keep the adjusting nut (A104) on the under side of the lever plate.
3.5 Use a hammer to tap another elastic pin (A106) into the axle with hole (A105).
The draw-bar is now assembled to the pump.
Chapter 4 To Adjust Release Device
On the draw-bar of this pallet truck, you can find the control handle(A117) which can be
regulated in three positions :
Raise -handle down
Drive position -handle in center position
Lower -handle up, the lever moves backthe drive position when released.
If however they have been changed, you can adjust according to following step:
4.1 If the forks elevate while pumping in the DRIVE position, turn the adjusting nut (A104)
on the adjusting bolt(A103) or screw(A318) clockwise until pumping action does not raise
the forks and the
DRIVE position functions properly.
4.2 If the forks descend while pumping in the DRIVE position, turn the nut(A104) or
screw(A318) counter-clockwise until the forks do not lower.
4.3 If the forks do not descent when the control handle (A117) is in the LOWER position,
turn the nut(A104) or screw (A318) clockwise until raising the control handle(117) lowers
the forks. Then check the
DRIVE position according to item 3.1 and 3.2 to be sure the
nut (A104) and screw(A318) is in the proper position.
4.4 If the forks do not elevate while pumping in the RAISE position, turn the nut (A104) or
screw (A318) counter-clockwise until the forks elevate while pumping in the RAISE
position. Then check the LOWER and DRIVE position according to item 3.1, 3.2 and
item 3.3.
Chapter 5 Maintenance
The pallet truck is largely maintenance-free.
5.1 OIL
Please check the oil level every six months. The oil can be hydraulic oil: ISO VG32, its
viscosity should be 30cSt at 40
0
C, total volume is about 0.4lt.
5.2 TO BANISH THE AIR
The air may come into the hydraulic oil because of transportation or pump in upset
position. It can cause that the forks do not elevate while pumping in the
RAISE position.
The air can been removed in the following way: let the control handle (A117) on the
LOWER position, then move the draw-bar up and down for several times.
5.3 DAILY CHECK AND MAINTENANCE