Stihl MS440, Инструкция по эксплуатации

Страница: 38 / 52

MS 440
English
36
General Information
The carburetor comes from the factory
with a standard setting.
This setting provides an optimum fuel-air
mixture under most operating
conditions.
Changing the setting of the high speed
screw alters the engine's power output
and the maximum off-load engine
speed.
Standard Setting
N
Stopping the Engine
N
Check the air filter and clean or
replace if necessary.
N
Check the spark arresting screen
(not in all models, country-specific)
in the muffler and clean or replace if
necessary.
Carburetors with H = 1 and L = 1
N
Carefully screw both adjusting
screws down onto their seats
(clockwise).
N
Turn the high speed screw (H) one
full turn counterclockwise.
N
Turn the low speed screw (L) one
full turn counterclockwise.
Carburetors with H = 3/4 and L = 1/4
N
Turn high speed screw (H)
counterclockwise as far as stop (no
more than 3/4 turn).
N
Turn the low speed screw (L)
carefully clockwise as far as stop,
then turn it back 1/4 turn.
Adjusting Idle Speed
N
Carry out the standard setting.
N
Start and warm up the engine.
Engine stops while idling
N
Turn the idle speed screw (LA)
clockwise until the chain begins to
run – then back it off 1/4 turn.
Saw chain runs while engine is idling
N
Turn the idle speed screw (LA)
counterclockwise until the chain
stops moving – then turn it another
1/4 turn in the same direction.
WARNING
If the chain continues moving when the
engine is idling, have your saw checked
and repaired by your servicing dealer.
Erratic idling behavior, poor acceleration
(even though standard setting of low
speed screw is correct)
Idle setting is too lean
N
Turn the low speed screw (L)
counterclockwise, no further than
stop, until the engine runs and
accelerates smoothly.
It is usually necessary to change the
setting of the idle speed screw (LA) after
every correction to the low speed
screw (L).
Adjusting the Carburetor
L
H
176BA008 KN
L
H
137BA023 KN
L
H
LA
L
137BA024 KN