Stihl MS440, Инструкция по эксплуатации

Страница: 33 / 52

MS 440
English
31
When the engine has turned over for the
first time
N
Press the button on the
decompression valve again
N
Move the Master Control lever (4) to
the
n
position and continue
cranking – once the engine runs,
immediately blip the throttle
trigger (5); the Master Control
lever (4) jumps to run
F
(6), and the
engine begins to idle
NOTICE
The engine must be switched to idle
immediately – otherwise, damage to the
engine housing and chain brake may
occur when the chain brake is locked.
N
Pull the hand guard toward the
handlebar:
U
. The chain brake is
released – the chain saw is ready for
use
NOTICE
Open the throttle only when the chain
brake is off. Running the engine at high
revs with the chain brake engaged
(chain locked) will quickly damage the
engine and chain drive (clutch, chain
brake).
N
first always check chain lubrication
At very low temperatures
N
Let the engine warm up briefly with
the throttle slightly open
N
if necessary, configure for winter
operation, see "Winter Operation"
Switching off the engine
N
Move the master control lever to the
stop position 0
If the engine does not start
The Master Control lever was not
returned to its "warm start" position
n
in
time when the engine turned over for the
first time and has now flooded.
N
Remove the spark plug, see "Spark
plug"
N
Dry the spark plug
N
Press the throttle trigger lockout –
open the throttle fully –
simultaneously crank the engine
several times with the starter – to
clear the combustion chamber
N
Reinstall the spark plug, see "Spark
plug"
N
Set the Master Control lever to
warm start
n
– even if the engine is
cold
N
Restart the engine
When the fuel tank has run completely
empty and then been refueled
N
Pull the starter rope several times to
prime the fuel line
6
4
5
145BA008 KN
0
STOP
143BA012 KN