Stihl MS 460, Руководство по обслуживанию

Страница: 59 / 94

58 MS 460, MS 460 C
The rewind spring is correctly
tensioned when the starter grip sits
firmly in the rope guide bushing
(arrow) without drooping to one
side. If this is not the case, tension
the spring by one additional turn.
When the starter rope is fully
VA
176RA194
extended, it must still be possible to
rotate the rope rotor at least another
half turn before maximum spring
tension is reached. If this is not the
case, pull the rope out, hold the
rope rotor steady and take off one
turn of the rope.
Do not overtension the rewind
spring as this will cause it to
break.
– Fit the fan housing with rewind
starter,
b
8.2
Wear on the guide bushing is
accelerated by the starter rope
being pulled sideways. The wall of
the bushing eventually wears
through and the bushing becomes
loose.
– Remove the fan housing with
rewind starter,
b
8.2
– Remove the rope rotor,
b
8.4
:
Pull knot (1) out of recess (2) in
rope rotor.
– Undo the knot.
:
Pull the starter rope out of the
rotor and guide bushing.
VA
176RA187
2 1
– Use a suitable tool to pry the
damaged bushing out of the fan
housing.
Installing the rope guide bushing
– Place the new bushing in its seat
in the fan housing/starter cover.
:
Insert the screw spindle (1) of the
installing tool 0000 890 2201
through the bushing from inside
the fan housing.
VA
176RA188
1
– Fit the thrust sleeve (1), tapered
end first, and the hex nut.
:
Tighten down the hex nut until the
bushing is firmly seated.
The installing tool flares the lower
end of the rope bushing.
VA
176RA189
1
– Remove the installing tool.
– Fit the starter rope,
b
8.5
– Install all other parts in the
reverse sequence.
8.6 Starter Rope Guide
Bushing