Stihl MS 460, Руководство по обслуживанию

Страница: 36 / 94

35 MS 460, MS 460 C
:
Carefully slide the cylinder over
the piston, the clamping strap
moves downwards at the same
time.
– Remove the clamping strap and
wooden assembly block.
VA
176RA087
:
To pull the manifold flange
through the intake opening in the
tank housing, wind a piece of
string (1) (about 15 cm long)
around the back of the flange and
pass the ends of the string
through the intake opening.
VA
176RA088
1
:
Press the manifold down.
:
Pull the ends of the string
outward.
The manifold flange is pulled
through the tank housing intake
opening without damaging the
manifold.
VA
176RA089
– Check that flange is properly
seated in the tank housing.
:
Fit sleeve (1) in manifold.
:
Fit the washer (2) on the studs.
Install all other parts in the reverse
sequence.
VA
176RA066
1
2
– Line up the cylinder and gasket.
:
Tighten down the cylinder base
screws in an alternate pattern,
b
3.5
VA
176RA090
:
Screw home the decompression
valve (2), if fitted, and tighten it
down firmly,
b
3.5
:
Fit the cover (1).
Install all other parts in the reverse
sequence.
VA
176RA085
1 2