MM 55, MM 55 C
English
7
Check the instruction manual for the
MultiTool to ensure you are using the
appropriate deflector for that MultiTool.
Starting
Start the engine at least 10 feet (3 m)
from the fueling spot, outdoors only.
For specific starting instructions, see the
appropriate section of your MultiEngine
and MultiTool manuals.
Place the power tool on firm ground or
other solid surface in an open area.
Maintain good balance and secure
footing.
Once the engine has started,
immediately blip the throttle trigger,
which should release the starting throttle
and allow the engine to slow down to
idle.
Stop the engine and working tool
immediately if you are approached.
To reduce the risk of eye and other injury
always wear proper eye protection (see
section on "Proper Clothing") and
ensure that bystanders are at least
16 feet (5 m) away. To reduce the risk of
damage to property, also maintain this
distance from such objects as vehicles
or windows. Any coworkers who must be
in the restricted area should also wear
goggles or protective glasses.
See also the safety precautions on
Starting in the instruction manual of the
MultiTool.
Important Adjustments
If you cannot set the correct idle speed,
have your STIHL dealer check your
power tool and make proper
adjustments and repairs.
Warning!
Always stand to one side of the unit to
avoid the risk of injury from contact with
the rotating working tool.
469BA027 KN
Warning!
To reduce the risk of
injury from loss of con
-
trol, be absolutely sure
that the working tool is
clear of you and all other
obstructions and
objects, including the ground, because
when the engine starts at starting-throt
-
tle, engine speed will be fast enough for
the clutch to engage and move the
working tool.
Warning!
Your power tool is a one-person
machine. Do not allow other persons in
the general work area, even when
starting.
5m (16ft)
Warning!
To reduce the risk of injury from loss of
control, do not attempt to "drop start"
your power tool.
Warning!
When you pull the starter grip, do not
wrap the starter rope around your hand.
Do not let the grip snap back, but guide
the starter rope to rewind it properly.
Failure to follow this procedure may
result in injury to your hand or fingers
and may damage the starter
mechanism.
Warning!
To reduce the risk of personal injury
from loss of control or contact with the
running working tool, do not use a
power tool with incorrect idle adjust
-
ment. At correct idle speed, the working
tool should not move. For directions on
how to adjust idle speed, see the appro
-
priate section of your instruction
manual.
