•
Take out screw and washer.
- Pull off the control handle.
Warning: To avoid risk of electric
shock, do not start the unit while
the control handle is open.
•
Remove screws with screwdriver
(1) 5910 890 2301.
- Separate two halves of handle.
•
Lift the interlock lever (1) slightly
and turn it to one side until the
torsion spring (2) is relaxed.
•
Pull the interlock lever off the
peg.
•
Remove the torsion spring.
•
Take the throttle trigger (1) with
torsion spring (2) and throttle
cable (3) off the peg.
•
Disconnect throttle cable from
trigger.
Assemble in the reverse
sequence.
•
Attach the throttle cable, then
position torsion spring as shown
and push its long arm into the
slot.
•
The interlock lever must be
behind the throttle trigger.
•
Check correct positions of
throttle cable (1), contact spring
(2), protective tube (3) and
insulator (4).
Throttle Trigger/Interlock Lever (Bike Handle)
26
FS 25-4, 65-4
