FC 70 C
English
8
To relieve vapor lock:
–
Place the Choke Lever in the cold
start position
g
and pull the starter
cord approximately 20 times to clear
the vapor and send liquid fuel into
the carburetor.
–
To start the power tool, move the
Choke Lever to the starting throttle
position
<
and pull the starter cord
approximately 10 times.
–
If your power tool will not restart, or
if vapor lock occurs again, the
power tool is being used in
conditions too extreme for the fuel
being used. Discontinue use and let
the engine cool completely before
attempting to start the power tool.
Before Operation
WARNING
Always check your power tool for proper
condition and operation before starting,
particularly the throttle trigger, throttle
trigger lockout, stop switch, cutting
blade, deflector and harness. The
throttle trigger must move freely and
always spring back to the idle position.
Never attempt to modify the controls or
safety devices.
WARNING
Check fuel system for leaks, especially
the visible parts, e.g., filler cap, hose
connections, manual fuel pump (only for
power tools equipped with a manual fuel
pump). Do not start the engine if there
are leaks or damage – risk of fire. Have
the power tool repaired by a STIHL
servicing dealer before using it.
WARNING
Never operate your power tool if it is
damaged, improperly adjusted or
maintained, or not completely and
securely assembled.
WARNING
Check that the spark plug boot is
securely mounted on the spark plug – a
loose boot may cause arcing that could
ignite combustible fumes and cause a
fire.
WARNING
Do not mount any cutting attachment to
a unit without proper installation of all
required parts. Failure to use the proper
parts may cause the blade to fly off and
seriously injure the operator or
bystanders.
WARNING
The cutting attachment must be properly
tightened and not damaged. Inspect for
loose parts (nuts, screws, etc.) and for
cracked, bent, warped or damaged
blades. Replace a damaged blade
before using the power tool.
Keep the handles clean and dry at all
times; it is particularly important to keep
them free of moisture, pitch, oil, fuel mix,
grease or resin in order for you to
maintain a firm grip and properly control
your power tool.
WARNING
An arrow on the deflector shows the
correct direction of rotation of the cutting
blade.
The arrow on the deflector must always
face away from you, so that cuttings and
other debris will be diverted away from
the machine and your position (see
chapter "Working Techniques".)
Adjust carrying harness and hand grip to
suit your size before starting work. The
machine should be properly balanced as
specified in your instruction manual for
proper control and less fatigue in
operation. To be better prepared in case
of an emergency, practise releasing the
unit from the harness as quickly as
possible.
To reduce the risk
of personal injury
to the operator
from blade con
-
tact and thrown
objects, make sure
your unit is
equipped with the
proper deflector,
handle and
harness.
239BA01
1 KN
Содержание FC 70
Страница 2: ...Instruction Manual 1 39 Manual de instrucciones 40 83...
Страница 86: ...FC 70 C espa ol EE UU 84...
Страница 87: ......