Stiga MFL 03, Руководство пользователя

Страница: 26 / 96

e
n
10.7 TYRE INFLATION
We recommend checking tyre inflation
before each machine use. The recom-
mended value is 21 PSI (1.5 bar).
Before inflating the tyre, always check
the maximum PSI value on the tyre.
11. CLEANING AND WASHING
Before proceeding, read and understand
the chapter "SAFETY INSTRUCTIONS”
in its entirety.
CAUTION!
DANGER!
be changed every 60 hours or so of work.
Lift the machine as described in the "HAN-
DLING AND TRANSPORT” chapter.
Then proceed as follows:
Use a syringe (not included) for easier
and safer extraction.
Use SAE 80 or equivalent oil.
Proceed in reverse order to reassemble
the wheel.
4.17 4.17 4.20 4.20 4.18 4.18 4.19 4.19
INFORMATION!
INFORMATION!
How often See chapt.
Checking the tightness of
fasteners and guards
Always before starting the machine - check that there are no untightened
screws, bolts and/or nuts and that the bonnets and protection systems are
intact and correctly fitted.
-
Cleaning
After each use 11.
Inflation
As needed 10.7
Greasing
After each use and after each wash 10.1
Blade adjustment
When cutting is not effective due to too much clearance between the two
blades
10.2
Blade replacement
When blade sharpening is no longer possible or when a dent cannot be
fixed by sharpening
10.3
Blade sharpening
Loss of blade cutting edge or dent 10.4
Cable adjustment
If operation is not as according to the manual 10.5
Base oil change
60 hours 10.6
Motor
See specific manual
12. MAINTENANCE PLAN
Possible cause See chapt.
The motor does not
start
No fuel; top up. 7.1.
Check the position of the accelerator. 7.2.
Check that the spark plug cap is properly inserted.
Specific motor
manual
Check the conditions of the spark plug and clean or replace if necessary.
Specific motor
manual
Check that the fuel cock is open (only for motor models for which the cock is
provided). Specific motor
manual
Motor power
decreases
Air filter dirty, clean it.
Specific motor
manual
Irregular grass
cutting
Correct the blade clearance 10.2.
Re-sharpen blade. 10.4.
Replace blade. 10.3.
The cutting bar is not
working.
Check the transmission cables. 10.5.
Belt broken.
Contact a special-
ised workshop.
Wheels are not
turning
Check the transmission cables. 10.5.
Contact the nearest authorised service centre if the problem cannot be solved.
Wait for all the hot parts to cool down (at
least 20 minutes) before washing and/or
cleaning the machine or the interchange-
able equipment. Use compressed air or a
sponge with neutral detergent and water.
Do not use pressurised water to wash the
machine and/or interchangeable equip-
ment. Doing so can damage the motor
and any electrical systems or batteries.
Avoid excessive use of water near labels.
In the event of damage, labels must be
replaced before using the machine and/
or the interchangeable equipment again.
CAUTION!
CAUTION!
13. TROUBLESHOOTING