Stiga HT 40 Li, Руководство оператора

Страница: 113 / 387

EN - 6
comply with these instructions to avoid
serious risks or dangers.
6.1 PRELIMINARY OPERATIONS
Before starting to work, it is necessary to carry
out several checks and operations to ensure you
can work efficiently and in maximum safety.
Place the machine in a stable
horizontal position on the ground.
6.1.1 Checking the battery
• Before each use:
– check the battery charge status according
to the instructions in the battery booklet.
6.2 SAFETY CHECKS
Run the following safety checks and
ensure that the results correspond
to those outlined in the tables.
Always carry out the safety
checks before use.
6.2.1 General check
Object Result
Handgrips (Fig. 1.C,
Fig. 1.D) and guards
Are clean, dry and fixed
firmly to the machine
Screws on the
machine and blade
Correctly tightened
(not loose)
Cooling air ducts Not clogged
Blade (Fig. 1.B) Sharp, without signs
of damage or wear
Guards Intact, undamaged.
Battery (Fig. 1.F) No damage to the casing,
no liquid leakage
Machine No signs of damage
or wear
Blade control lever (Fig.
3.A), blade control locking
button (Fig. 3.B) and
safety switch (Fig. 3.C)
The levers must move
freely and not be forced.
Test driving No abnormal vibrations.
No abnormal sound
6.2.2 Machine operating test
Action Result
Start the machine
(para. 6.3 );
1. Simultaneously
operate the blade
control lever (Fig.
3.A), blade control
locking button (Fig.
3.B) and the safety
switch (Fig. 3.C) ,
2. release the blade
control lever (Fig.
3.A) or the safety
switch (Fig. 3.C)
1. The blade should move
2. The controls should
return automatically
and rapidly to the
neutral position and
the blade should stop
If any of the results fail to match
the indications provided in the tables
below, do not use the machine! Take
it to a service centre to be checked
and repaired if necessary.
6.3 START-UP
1. Remove the blade guard (Fig. 1.E) (if used);
2. make sure the blade is not touching
the ground or any other object;
3. fit the battery inside its housing
correctly (para. 7.2.3);
4. simultaneously operate the blade control
lever (Fig. 3.A), blade control locking button
(Fig. 3.B) and the safety switch (Fig. 3.C),