Stiga HT 40 Li, Руководство оператора

Страница: 115 / 387

EN - 8
• when the cutting means is stationary,
apply the blade protection device, (except
when working directly on the blade);
• allow the engine to cool before
storing in an enclosed space;
• use suitable clothing, protective
gloves and goggles;
• read the relevant instructions.
– The frequency and type of procedures are
outlined in the "Maintenance table" (see
chap. . 13). The table will help you maintain
your machine’s safety and performance.
It summarises the main interventions to
be made and the frequency applicable to
each of them. Carry out the relevant task as
soon as it is scheduled to be performed.
– The use of non-original parts and
accessories could have negative effects
on machine operation and safety. The
manufacturer declines any responsibility for
damage or injury caused by said products.
– Genuine spare parts are supplied
by Authorised Assistance
Centres and Dealers.
IMPORTANT Any maintenance and
adjustment operations not described in
this manual must be carried out by your
dealer or Authorised Service Centre.
7.2 BATTERY
7.2.1 Battery power reserve
Battery power reserve (and therefore the
cuttable vegetation area before recharging
is required) mainly depends on:
a. Environmental factors, that cause
higher energy requirements:
– cutting/trimming of very thick or wet hedges;
– cutting/trimming of bushes with
branches that are too thick;
b. operator behaviour that should be avoided:
– switching the machine on and off
frequently whilst working;
– adopting a cutting technique
that is unsuitable for the work to
be performed (para. 6.4.1);
– cutting speed unsuitable for the
condition of the hedge to be cut.
To optimise battery power reserve
it is always recommended to:
• cut the hedge when dry;
• set a cutting speed suitable for
the condition of the shrubs;
• use the most appropriate technique
for the work to be performed.
If the need arises to use the machine for
sessions which exceed the capability of
a standard battery, it is possible to:
• purchase a second standard battery
to immediately replace the discharged
battery, without compromising
the continuity of operations;
• purchase a battery with an extended
power reserve compared to the
standard version (para. 15.1).
7.2.2 Battery removal and recharging
1. Press the buttons on the battery (fig.
6.A) and remove it (Fig. 6.B);
2. fit the battery (Fig. 7.A) in the battery
charger housing (Fig. 7.B);
3. connect the battery charger (Fig. 7.B)
to a power socket with the voltage
indicated on the rating plate;
4. fully charge the battery according
to the instructions in the battery/
battery charger booklet.
NOTE The battery is equipped with a guard
that inhibits recharging if the environmental
temperature is not between 0 and +45°C.
NOTE The battery can be recharged at any
time, even partially, with no risk of damaging it.
7.2.3 Refitting the battery on the machine
When recharging is completed:
1. Remove the battery (Fig. 8.A) from
the housing in the battery charger
(do not continue recharging when
recharging is completed);
2. disconnect the battery charger
(Fig. 8.B) from the mains;
3. fit the battery (Fig. 9.A) in its housing
pressing down until you hear it click firmly
into position and check the electrical contact;
7.3 CLEANING THE MACHINE
To reduce fire hazards, keep the machine
and, in particular, the motor free of leaves,
branches or excessive grease.
• Always clean the machine after use with a
damp cloth dipped in neutral detergent.
• Remove all traces of humidity using
a soft damp cloth. Humidity can
generate risks of electric shocks.