Stiga H 60, Руководство оператора

Страница: 18 / 22

12 IDENTIFICATION OF FAULTS / TECHNICAL SPECIFICATIONS / ACCESSORIES
EN
8. IDENTIFICATION OF FAULTS
PROBLEM LIKELY CAUSE SOLUTION
1) The engine
will not start
or will not
keep running
2) The engine starts
but is lacking
in power
3) The engine runs
irregularly and lacks
in power when
revved
4) The engine gives
off an excessive
amount of smoke
– Incorrect starting procedure
– Dirty spark plug or incorrect distance
between the electrodes
– Air filter clogged
– Carburation problems
– Air filter clogged
– Carburation problems
– Dirty spark plug or incorrect
distance between the electrodes
– Carburation problems
– Incorrect composition
of the fuel mix
– Carburation problems
– Follow the instructions
(see chap. 5)
– Check the spark plug
(see chap. 7)
– Clean and/or replace the filter
(see chap. 7)
– Contact your Retailer
– Clean and/or replace the filter
(see chap. 7)
– Contact your Retailer
– Check the spark plug
(see chap. 7)
– Contact your Retailer
– Prepare the fuel mix according to
the instructions (see chap. 4)
– Contact your Retailer
Only cutting tools with the following codes must be
used on this machine:
23305004/0
Given the product evolution, the above mentio -
ned tools may be replaced in time by others, with
similar interchangeable and operating safety cha -
racteristics.
10. ACCESSORIES
9. TECHNICAL SPECIFICATIONS
Capacity cm 3 24,5
Power kW 0,85
Spark plug BOSCH L8RTF
Petrol : Oil ratio 40 : 1
Tank capacity liters 0,41
Trimming lenght mm 550
Weight kg 5,5
Measured sound pressure level at ear’s operator
- Measurement uncertainty
dB(A)
dB(A)
95,62
2,5
Measured sound power level
- Measurement uncertainty
dB(A)
dB(A)
107,06
2,5
Guaranteed acoustic power level dB(A) 109
Vibrations transmitted to the hand on the front handgrip
- Measurement uncertainty
m/s 2
m/s 2
3,590
1,5
Vibrations transmitted to the hand on the rear handgrip
- Measurement uncertainty
m/s 2
m/s 2
3,494
1,5