Stiga H 60, Руководство оператора

Страница: 17 / 22

The machine must be preserved in a dry area,
protected from all weather conditions and with the
blade protection device correctly fitted.
PROLONGED IDLE PERIODS
IMPORTANT
If the machine will not be
used for a period of more than 2­3 months it is
recommended to follow some advice to avoid dif­
ficulty when you wish to use the machine and to
prevent permanent damage to the engine.
• Storage
Before storing the machine:
– Empty the fuel tank.
– Start the engine and allow it to tick over until it
comes to a halt, so that it uses all the fuel that is
left in the carburettor.
– Allow the engine to cool down and remove the
spark plug.
– Pour a a teaspoon of (new) 2-stroke engine oil
into the spark plug slot.
– Pull the starter wire a couple of times to dis -
tribuite the oil in the cylinder.
– Replace the spark plug with the piston in the
dead end upper position (visibile from the spark
plug slot when the piston is at maximum stroke).
• Restarting work
When you wish to start using the machine again:
– Remove the spark plug.
– Pull the starter wire a couple of times to elimi -
nate all excess oil.
– Check the spark plug as described in chapter
“Checking the spark plug”.
– Prepare the machine as indicated in the para -
graph entitled “Preparing for work”.
– Carefully remove any dust or debris from the
slots (4).
– Lubricate the internal surfaces of the blades.
– Remount the bar (3) with the screws (2), taking
care to reposition the spacers accurately (5) and
the washers (6) and (7) under the nuts (1).
– Fully tighten the nuts (1).
WARNING!
Always check that the
nuts (1) are tightened as far as possible be-
fore starting work.
SHARPENING THE BLADES
It is necessary to sharpen the blades when
the trimming performance decreases and the
branches tend to stick together.
WARNING!
Always replace and never
repair a blade which has blunt cutting edges
IMPORTANT
We recommend you take your
machine to your Retailer for sharpening as he has
the required tools and suitable experience.
In order to sharpen the blades, it is recommended
to use a fine grain file and proceed as follows (Fig.
12):
– Place the file (1) on the blade (2) at a 45° angle,
and proceed with upward strokes towards the
cutting edge.
– Make sure that you put pressure on the file only
when stroking upwards and raise it from the
blade when you move it back towards you.
– Only remove a smallest amount of material.
– Eliminate any burr with a grinding stone.
– Eliminate all grinding traces and lubricate the
blades before reassembling them.
EXTRAORDINARY INTERVENTIONS
All maintenance operations not foreseen in this
manual must be performed exclusively by your
Retailer.
All and any operations performed in unauthorised
centres or by unqualified persons will totally invali -
date the warranty.
PRESERVATION
After each working session, carefully clean the
machine from dust and debris, repair or replace
any faulty parts and lubricate the blades to prevent
them from rusting.
MAINTENANCE AND PRESERVATION 11
EN