Stiga Chain-saw, Руководство оператора

Страница: 14 / 22

EN
HOW TO START - USE – STOP THE ENGINE 9
If the machine is not held
firmly, the force of the engine could cause the
user to lose his balance or direct the bar
towards him or an obstacle.
7. Pull the starter rope slowly for 10 - 15 cm until
you feel some resistance, then tug it hard a
few times until you hear the engine turn over.
To avoid breaking the starter
rope, do not pull the whole length of it or let it
slide along the edge of the cable guide hole.
Release the starter gradually, to avoid letting it fly
back uncontrollably.
8. Pull the starter rope again until the engine
starts as normal.
9. When the engine has started, press the throt-
tle trigger to disconnect the starter and allow
the engine to idle.
Do not let the engine run at
high power with the chain brake engaged, as this
could cause overheating and damage to the
clutch.
10. Let the engine run idle for at least 1 minute
before using the machine.
If the starter rope is pulled
repeatedly with the choke on, it may flood the
engine and make starting difficult.
If you have flooded the engine, remove the spark
plug and gently pull the handle on the starter
rope to eliminate any excess fuel; then dry the
spark plug electrodes and replace it on the
engine.
• Hot starting
When hot starting (immediately after stopping
the engine), follow the procedure indicated
above in points 1 -2 -6 - 7 -8.
IMPORTANT
IMPORTANT
IMPORTANT
!
WARNING!
USE OF THE ENGINE (Fig. 14)
The chain speed is regulated by the throttle trig-
ger (1) on the rear handgrip (2).
The throttle trigger only works if the lockout (3) is
pressed at the same time.
The movement is transmitted from the engine to
the chain by a centrifugal mass clutch that pre-
vents the chain from moving when the engine is
running at minimum speed.
Never use the machine if
the chain moves when the engine is running
idle; if this is the case regulate the minimum
rate (see chap.8) and if the problem persists
please contact your dealer.
The correct running speed will be achieved by
pressing the throttle trigger (1) as far as possible.
Avoid using the engine at full
power for the first 6-8 working hours.
STOPPING THE ENGINE (Fig. 14)
To stop the engine:
– Release the throttle trigger (1) and allow the
engine to run idle for a few seconds.
– Set the switch (4) to “STOP”.
When you have reduced
speed to a minimum, it will take a few sec-
onds for the chain to stop.
!
WARNING!
IMPORTANT
!
WARNING!