50
User’s manual
EN
Problem
Cause
Remedies
The robot does not
behave correctly
around the fl owerbeds
Perimeter wire laid
incorrectly
Reposition the perimeter wire correctly
(anti-clockwise direction
(see “Installation of perimeter wire”)
The robot works at
the wrong time
Clock was set
incorrectly
Reset the clock of the robot
(see “Programming Mode”)
Working time was set
incorrectly
Reset the working time
(see “Programming Mode”)
The robot does not
execute the
quick re-entry
Quick re-entry not
setup correctly
Check the exact layout of the quick re-entry
(see “Layout of the robot’s quick re-entry to
the charging station”)
The work area is not
completely mowed
Not enough work
hours
Reset the working time
(see “Programming Mode”)
Cutting blade fouled
Stop the robot safely
(see “Robot Safety Stop”).
Use protective gloves to prevent injury.
Clean the cutting blade
Cutting blade worn
out
Replace the blade with an original spare part
(see “Blade replacement”)
Work area too big
compared to the
actual capacity of the
robot
Adjust the work area
(see “Technical specifi cations”)
The batteries are
about to run out
Replace the batteries with original spare
parts (see “Battery replacement”)
The batteries do not
charge completely
Clean and remove any oxidisations from the
contact points of the batteries (see “Robot
Cleaning”). Recharge the batteries for at
least 12 hours
Warning - Caution
