WORKSHOP MANUAL
PARK
Chapter
7 - WHEELS - TRANSMISSION - BRAKE
EDITION
2020
PAGE
80 /
124
6. Unscrew the two screws (13), remove the plate
(12) and release the cable (6) from the ring of
the support bracket (14).
7. Unscrew the nut (15) and disconnect the ball
joint (16) of the cable (6) from the front lever
(17) of the traction.
8. Remove the cable by pulling it from the front of
the machine.
IMPORTANT
The cable (6) is supplied as spare
parts without the two ball joints (5) and (16); there-
fore, before the assembly, the two joints must be
screwed to the two threaded ends of the cable,
leaving exposed a threaded section of 5 mm from
the rear and placing the centre of the front joint at
151 mm from the joint point on the lever support
bracket (19)
.
Compliance with these dimensions
allows the cable to be reassembled without the
need for subsequent adjustments. Check the di-
mensions, lock the respective lock nuts (18).
NOTE
If entire gear lever (19) has been removed,
connect the pin (20) to the central hole of the
pedal lever (21).
6
12
13
14
16
15
6
17
20
21
19
6
5 mm
5
▶▶
4WD
18
18
16
151 mm
19
