Stiga 2021 Edition PARK 320 P, Руководство по ремонту

Страница: 51 / 124

WORKSHOP MANUAL
PARK
Chapter
5 - ENGINE AND FUEL TANK
EDITION
2020
PAGE
51 /
124
8. Proceed to harness and remove the engine.
WARNING! Apply the lifting ropes in points that offer sufficient reliability and
proceed with the removal of the engine, taking into account a weight of approximately
50-55 kg.
When assembling, perform the steps described above in reverse order, taking care to:
– Do not interchange the throttle and choke cables.
NOTE Replacement cables have a predetermined length and do not require adjustment; for
this reason it is necessary to use specific cables for each type of engine and function, without
exchanging them or using cables of different engines.
– Tighten the engine fixing screws (14) using a torque wrench set to 35-50 Nm.
5.1.3 Removal and replacement of the exhaust muffler
WARNING! Wait for the engine and muffler to cool before carrying out any type of
work on the rear of the machine.
1. Remove the rear hood [ 3.1.1] .
2. Remove the fuel tank [ 5.2.1]
3. Working from the right side of the machine, un-
screw the two nuts (1) that lock the clamp (2)
that fixes the exhaust manifold (3) of the en-
gine to the muffler (4).
4. Unscrew the screw (5) taking care to support
the muffler (4) from the right side.
5. Applying slight movements, cause the disen-
gagement between the manifold (3) and the
muffler until it can be removed.
When assembling, perform the steps described
above in reverse order.
4
5
4
3
1
1 2