Stierius EG 30-60 EPC, Руководство по эксплуатации

Страница: 21 / 42

21
Note
If the device is switched on and still shows no function, the power supply may be
interrupted. Backup devices (6) review and, where appropriate, renewed. Strength?
To the resulting pressure to dismantle the device before a new lower setting on the
pressure regulator (9) on the device ON/OFF-switch (5) off. Then pressure regulator
knob on the pressure regulator (9) to the left; device and desired pressure by turning
right setting.
Important:
After bleeding the brake system with a lower or higher pressure than 2 bar, the
pressure regulator must be reset to 2 bar!
When does the unit needs to be refilled?
After reaching a low level of brake fluid inside the container, the unit will shut off the
motor + pump automatically. This will ensure that no air will reach the brake system at
all.
As an additional control an acoustic warning signal and the control lamp (7) lights up.
In this case, the empty brake fluid container must be exchanged for a full one. For this
the unit should be turned off on the ON/OFF switch (5). Please continue the procedure
ac
cording to the heading “Operation start-up”.
Disposal
The unit is to be returned to your sales partner or be disposed off in compliance with
the legal and official waste regulations.
GB