INSTALLATIoN
Installation
EN
GL
ISH
www.stiebel-eltron.com
ETS 200-700 Plus |
41
f
f
Remove the cover panel and cardboard inserts from the inte-
rior of the appliance.
The storage blocks are delivered in separate packaging. Storage
blocks with slight transport damage can be used. This does not
impair the function of the appliance.
D
00000
75
746
1
2
1 Heating element
2 Storage block
f
f
To insert the storage blocks, raise the heating elements
slightly.
f
f
When raising the heating elements, ensure the through
holes in the side insulation are not widened by the heating
elements.
f
f
Insert the first storage block, with the heating element cavity
pointing upwards, with some clearance to the r.h. thermal
insulation.
D
00000
75
74
7
f
f
Push the storage block up against the r.h. and back thermal
insulation. The long holes form the heating ducts.
f
f
Insert the other storage blocks in the order shown.
D
00000
75
74
8
f
f
Push the cover panel taken from the interior of the appliance
over the upper storage blocks.
12.7 Cleaning the appliance
f
f
Clean the appliance after installation and inserting the stor-
age blocks. For this, proceed as follows:
D
00000
75
80
3
f
f
Remove the air routing assembly.
D
00000
75
80
4
1
1 Protective temperature controller (N5)
f
f
Lift the fan out. To do this, loosen the screws located at the
front on the retaining brackets.
f
f
Observe the cable routing.
With some appliances, the protective temperature controller (N5)
incl. retaining bracket must be unscrewed.
Material losses
When depositing the components you have removed,
ensure that the wires are not damaged.
f
f
Clean the floor plate and fan. Make sure not to damage the
fins.
f
f
Then refit the fan, and if necessary the protective tempera-
ture controller and air routing assembly.
f
f
Observe the correct cable routing.