STIEBEL ELTRON DEL 18 AU, Эксплуатация и установка

Страница: 11 / 24

EN
GL
ISH
www.stiebel-eltron.com DEL AU| 11
INSTALLATION
Installation
f f
When installing connection pipes that are not offset, break
off the tabs on the cover guides.
f f
Click the cover guides into place in the pipe apertures.
f f Position the back panel guides on the extensions. Push them
together. Then push the guides until they are resting against
the back panel.
10.3 Installation options
- Electrical connection from above on unfinished walls
- Electrical connection for finished walls
- Large cross-section for electrical connection from below
- Water installation on unfinished walls
- Wall mounting bracket when replacing an appliance
- Installation with offset tiles
- Pivoting appliance cover
- Operation with preheated water
- Anti-scalding protection / temperature limit
Electrical connection from above on unfinished walls
26
�02
�02
�1
12
3�
f f Cut open the cable grommet for the power cable.
f f
Push down the locking hook to secure the mains terminal.
Pull out the mains terminal.
f f
Reposition the mains terminal in the appliance from the
bottom to the top and secure the mains terminal by sliding it
under the locking hook.
f f Lay the control wires below the wire guide.
Power cable for finished walls
!
Material losses
If you cut open the wrong knock-out in the appliance
cover by mistake, you must use a new appliance cover.
f f
Cut or break out the required entries in the back panel and
appliance cover cleanly (for positions, see chapter "Specifica-
tion / Dimensions and connections"). If necessary, use a file.
f f Route the power cable through the cable grommet. Connect
the power cable to the mains terminal.
Note
This type of connection changes the protection rating of
the appliance.
f f Change the type plate. Cross out "IP 25" and mark
the box "IP 24". Please use a ballpoint pen to do this.
Large cross-section for electrical connection from below
If you use cables with a large cross-section, you can fit the cable
grommet after the appliance has been installed.
1.
3.
4.
2.
26
�02
�02
�1
12
4�
f f
Before installing the appliance, use a screwdriver to push out
the cable grommet.
f f
Slide the cable grommet over the power cable. For this, use
the installation aid. If the cross-section is > 6 mm², enlarge
the hole in the cable grommet.
f f Push the cable grommet into the back panel.
Water installation on unfinished walls
26
�0
2�
02
�0
79
8
f f
Seal and screw in the twin connectors (not included in stand-
ard delivery).
D
00000
41
72
4
2
3
1
3
1 Tee for cold water
2 Tee for domestic hot water
3 Cover
f f Fit the water connections.