STF-Filtros FMA-3000, Инструкция по установке, эксплуатации и обслуживанию

Страница: 19 / 41

Installation, Operation and Maintenance Manual – FMA 3000
Ref: 3000/T/6/VH 19
8. – INSTALLATION INSTRUCTIONS
 Take any necessary precautions to prevent bumping the filter. Lift the device by using the
anchoring points at the top.
 Make sure the installation point has the minimum operating pressure.
o
The discharge pipe should be dimensioned to generate a minimum pressure loss
at a flow rate of 30 m³/h.
o
In facilities with a working pressure above 6 bar, we recommend installing a ball
valve on the discharge pipe in order to adjust the washing flow.
NOTE
MINIMUM OPERATING PRESSURE IS 2 BAR BETWEEN FILTER OUTPUT
AND DRAIN VALVE.
IN THE EVENT THAT THE DRAINAGE IS REDIRECTED, THERE MAY BE
BACKPRESSURE DUE TO PRESSURE DROP AND INCREASES IN
HEIGHT.

Install filter vertically, make sure to leave enough space to allow easy access to your
device for future treatments and to perform maintenance safely. See section 6.
 Orient the filter in the pipe according to the arrows indicating water flow direction.

It is recommended to install shutoff valves at the inlet and outlet of the filter to allow
insulation from the pipe. To avoid outages during maintenance, it is recommended to
install a bypass.

We recommend installing an anti-backflow valve at the outlet to prevent water hammer in
the filter.
 The electrical wiring can only be carried out by a licensed electrician in accordance with
section 12.1
 When installing the filter, prevent water from splashing onto the electrical components or
the control panel.