Stewart Filmscreen Luxus Grande S6, Руководство пользователя

Страница: 7 / 16

Luxus Grande 7
STEP 2: ELECTRICAL HOOK-UP
i i
CAUTION
Professional techniques need to be used when making any electrical connection A qualified
electrician should perform these procedures
Be sure to follow all standard safety procedures for installing electrical devices
Do not disassemble or alter the configuration of the motor or the unit’s electrical connections This
may cause injury to you or damage to the product
The electrical connection should be made only to the type of power source indicated on the
marking label
The motor requires standard AC input (unless an alternate voltage has been specified) All connections
are made to the electrical box on the side of the unit (audience left)
There are several kinds of switch controls available Follow the installation procedure for the type of
switch control you will install
General suggestions for wiring:
`
Soldering is recommended
`
The use of wire nuts is acceptable
INSTALLING THE LOW-VOLTAGE 3-BUTTON SWITCH (STANDARD)
The Stewart Filmscreen low-voltage control allows the use of low-voltage wire to connect to the supplied
3-position 24V momentary wall switch
PREPARING THE CONNECTION
Before making the electrical connections, you need:
`
An available AC constant power source
`
A 4-conductor switch hook-up cable (4-conductor bell wire or category 5 cable is typically used for
long runs)
`
Cat 5, multi-conductor unshielded, or similar type electronic cable can be used to connect the
3-button switch to the LVC The recommended wire gauge is 20 to 24 AWG Use plenum-rated cable
when required