Stewart Filmscreen Corp VCS-1007, Руководство пользователя

Страница: 8 / 16

6 Stewart Filmscreen Corporation
The motor requires standard AC input (unless an alternate voltage has been
specified).
This manual includes instructions for LVC (low voltage control) switch. If
your systems uses another type, be sure you know how to make the
connections. Contact the factory as needed.
General suggestions for wiring:
Soldering is recommended.
The use of wire nuts is acceptable.
Preparation—Removing access panel
All connections are made to the electrical box on the side of the unit
(audience left). An access panel covers the electrical connections. To
remove the access panel on the underside of the unit, remove the two hex
screws. Replace the access panel after the electrical connections have been
made.
High voltage AC input connection
We advise this connection be done by a qualified AV technician or
electrician. Stewart Filmscreen Corp. cannot be held liable for faulty or
substandard connections.
Connect the AC input line to the electrical junction box located on the left
end of the housing. You will make three connections:
White is neutral.
Black is hot.
Green is ground.
Use 3 conductor 16 ga minimum romex or service cord for hookup. Wire
nuts can be used for the connections.
S
TEP
2. E
LECTRICAL
C
ONNECTION
Caution
Professional techniques should be used when making any
electrical connection. A qualified electrician should perform
these procedures.
Be sure to follow all standard safety procedures for
installing electrical devices.
Do not disassemble or alter the configuration of the motor
or the unit's electrical connections. This may cause injury to
you or damage to the product and will void the product
warranty.
The electrical connection should be made only to the type
of power source indicated on the marking label.