AV25-2 User Manual Rev A
Page 9
Table of Contents
Top
screwdriver, tighten the screw until the leads are held securely in place. Inspect for possible shorts or
broken wires.
In normal operation, the DC voltage on the speaker output
connectors is approximately 24VDC. Do not connect any
speaker output to ground or to the amplifier chassis. Do not
connect speakers across speaker outputs. (Bridge mode is not
supported.)
NOTE: Class 2 wiring must be used on the speaker terminals to comply with UL
requirements.
CAUTION: Do not connect either speaker terminal to ground. This will cause a short circuit
which may damage the amplifier, speaker, or both. Similarly, do not connect any speaker
terminal to ground.
