AV25-2 User Manual Rev A
Page 11
Table of Contents
Top
Amplifier overheats and/or shuts off.
Review
section5.3.3
on proper cooling procedures. Check the signal lights on the rear of the
amplifier to see if the signal is overdriving (the clip light flashes red frequently). Overdriving
the amplifier for extended periods of time can result in a thermal shutdown.
Output sound is distorted or cracking.
Check all cables for damage or loose connections and reduce the gain on the input signal at
the mixer or preamp level. Replace the cables and loudspeakers temporarily to see if this
resolves the problem. If problem still exists, contact your Authorized Dealer for service.
9
Warranty Information
9.1
Warranty Summary
All Stewart Audio amplifiers and accessories, unless excluded in this summary, are covered by a 3-
year limited warranty on parts and labor from the data of purchase. In order to be eligible for
warranty repairs, the amplifiers and accessories must have been purchased through an authorized
Stewart Audio dealer and submitted by the original purchaser. This warranty is only valid in the
country in which the amplifier was purchased.
9.2
Eligibility Requirements
Stewart Audio warrants against all malfunctions which come as a result of component or
manufacturer defect. The amplifier is also covered from all failures which arise during the warranty
period (3 years from date of purchase) that are not a result of misuse. The following actions will void
your warranty:
The power cord or AC plug has been damaged through misuse.
The amplifier has been exposed to moisture or extreme temperatures.
The amplifier has been dropped, items have been dropped on the amplifier, or the enclosure
has been damaged.
The amplifier has been opened by the operator.
The amplifier was improperly packaged when sending to the factory for repair, resulting in
damage.
Any of the precautions or instructions found in this manual were not followed.
Damages resulting to the amplifier which are not covered under this warranty can be factory-repaired
at cost to the customer. Use the contact information below to initiate the repair process.
9.3
Non-warranty Repairs
An estimate for all non-warranty repairs will be provided to the customer once the unit has been
