Non-USA Applications: Removing eTracker,
Programming APN on SD Card, Inserting SIM
To install standard size SIM, you must remove
the cover to the eTracker. Do so by removing
the 2 Philips screws on the antenna side of
the eTracker and pulling the board outward
away from the housing gently
To install the SIM, unlock the SIM clamp by
sliding forward and lifting up. Once SIM is
inserted, fully seat clip and slide back to lock
it in place
To program the APN on the SD Card, remove
the SD Card by pressing in from the outer
edge and it will pop out, plug into a PC
enabled with an SD Card reader and follow
the instructions for programming (previous
page). Reinsert the SD Card by pushing all the
way in until it clips in place
18
To remove the eTracker, grab it securely and pull it from
the box wall. It is secured with industrial strength
Velcro. Once detached, you can disconnect the power
connector on the right side beneath the antenna and
remove the sensor interface box on the left side as
described in the previous page instructions
