Build Instructions
Wing
(continued)
53. Fit sub-ribs W9 and W10 (sheet 04/10, 1/16 in. balsa) to the spar and leading edge web.
Refer to the plan on the detail sheet for the correct location of each rib.
54. Fit the diagonal braces W11 through W14 (sheet 03/10, 1/16 in. balsa)
between
the ribs on
each wing panel. Refer to the plan on the detail sheet for the correct location of each
brace. Hold one wing panel down on a flat surface, and bond all parts of that panel with
CA. Repeat for the other panel.
55. Position the trailing edge brace W15 (sheet 09/10, 1/32 in. ply) into the recess in the
center
of the trailing edge, and bond with CA.
56.
Wing Tip Panels -
Fit the tip spar W16 (sheet 03/10, 1/16 in. balsa) to rib W4, oriented so
that the etched side faces
forward
. Align the long tabs on the main spar W1 and W16
within
the etched lines on each spar. Bond with CA.
57. Fit ribs W17, W18, and W19 (sheet 04/10, 1/16 in. balsa) onto the spar W16. Refer to the
plan on the detail sheet for the correct location of each rib.
58. Assemble the wing tip outline from parts W20 and W21 (sheet 05/10, 3/32 in. balsa) and
bond with CA.
59. Fit the wing tip outline to the ribs, spar, leading and trailing edges. Bock up the inner panels
until the wing tip lies flat one the work surface. Hold the wing tip down, and bond all parts
with CA.
60. Fit the wing tip leading edge W22 (sheet 05/10, 3/32 in. balsa) to the
front
of the ribs.
Carefully align the front face of W22 with the
front
face of W21, then bond them together
with CA.
Ace (100)
- Build Instructions © 2017 Stevens AeroModel, all rights reserved.
Page 22
□
□
□
□
□
□
□
□
