Build Instructions
Fuselage
(continued)
8.
Receiver Tray: Lay F8 (sheet 03/10, 1/16 in. balsa) on the work surface with the etched side
facing
up
. Fit the nylon receiver clip found in your hardware bag to F9 and F10, then fit and
bond the receiver tray to the four slots in the middle of F8. Orient the tray so that the
long
arm of the clip is toward the
front
(tapered end) of F8.
9.
Turn the crutch assembly up side down and fit F8 to the
bottom
of formers F6 and F7,
oriented so that the receiver tray is on the
bottom
of the model.
10. Turn the assembly right side up. Fit and tack glue former F11 (sheet 02/10, 1/16 in. balsa)
to the slots in F8
forward
of former F6.
11.
Fit and bond the nose spine F12 (sheet 03/10, 1/16 in. balsa) to formers F6 and F11,
oriented so that the long tab at one end of F12 points
forward
.
12.
Motor Mount -
Lay the motor mount plate F13 (sheet 09/10, 1/32 in. ply) on the work
surface with the side etched ‘Top’ facing
up
. fit and bond two F14’s (sheet 09/10, 1/32 in.
ply) to the
top
of F13.
13. Slide former F15 (sheet 10/10, 1/16 in. ply) onto the long tabs on the
front
of the two F14’s,
and the short tabs on the
front
of F13.
14. Fit the motor mount assembly to the long tab at the
front
of F12, and the short tabs at the
front
of F8. The tab at the
rear
of F13 will fit in the recess in the
top
of the opening in former
F11. Bond with CA.
15.
Fuselage Sides -
Assemble the fuselage sides by laying F16a (sheet 01/10, 1/16 in. balsa)
on the work surface, then fitting and bonding F16b and F16c (sheet 01/10, 1/16 in. balsa) in
place, using CA.
Ace (100)
- Build Instructions © 2017 Stevens AeroModel, all rights reserved.
Page 10
□
□
□
□
□
□
□
□